Car seat cover installation method Different treatment according to different cars

Most car owners think that the installation of a car seat cover is simply to put the seat cover on the car seat. This understanding of the car is incorrect. There is a way to install the seat cover. Let us look at the seat together. Set the specific method of installation.

The installation method of the seat cover, because different vehicles have different safety methods, so when installing the seat cover, you need to know where the differences are during each installation. The following is the specific installation method.

Front backrest: First, unplug the headrest (usually you can fix it by pressing the headrest); then cover the backrest cover (see if the front, back, left and right covers are correct); then, connect the front cover back to the seat. Place it on the back of the backrest, and fix it with the adhesive tape on the bottom of the backrest cover a little bit, so that it will be more tight; then insert the headgear and insert it into the backrest; finally, arrange the backrest to be flat, and the front backrest is installed.

Front Seat: Put the seat cover on the seat and adjust the position (the front two corners of the seat are pulled apart); there are extra parts near the backrest and the Velcro and rope are plugged directly along the gap to the backside, and the ropes on both sides Pull as far as possible to the bottom of both sides; tighten the rope on the side of the seat tightly, and then pass the Velcro to the bottom of the seat. There are two work buckles on both sides below the seat. The Velcro is opened to pass through the open buckle and tighten it against the adhesive. White bottom surface; then arrange the seat cover flat, and the front seat is installed. The installation of the front passenger seat is the same as this method.

Backrest: first remove the headrest, press the movable pin of the backrest in different ways to remove the headrest according to different structures of the car; then cover the backrest, and distinguish between the upper and lower parts when placing, and put it in the correct position; The rubber band at the bottom of the front back cover is plugged into the back. The rubber band is strung from below to the back and tied with the upper rubber band. The side rubber band and the side rubber band are tied together. Then the set back is smoothed and inserted into the head. The pillow and backrest are installed.

Rear seat: the back seat of the general car is pulled up slightly, the entire seat can be flipped up directly, then the installation is quite simple; first place the seat on the seat and adjust the position; the rear end of the front seat The rubber band is pulled from below the seat to the back and tied with the rubber band at the back; then the rope at the rear end is tightened tightly; then the seat cover is arranged and flattened, and the rear seat installation is completed.

The specific installation method is like this, it is very simple, you can install it by yourself after purchasing the seat cover. Tips, careful installation will be better.